Error Code Message Meanings Field replaceable unit or action

0175

 Bad CRC1, stop POST task EEPROM CRC1 is not correct (block number 6). System board
0176 System Security. The system has been tampered with. Security Chip was removed and attached again.
  1. Run the BIOS Setup Utility and then save the current setting by pressing the F10 key
  2. System board

0187

 EAIA data access error EEPROM access (read or write) failed. System board

0188

 Invalid RFID Serialization Information Area or Bad CRC2 EEPROM checksum is not correct (block number 0,1). EEPROM CRC2 is not correct (block number 6). System board
Box serial number needs to be reinstalled.

0189

 Invalid RFID Configuration Information Area EEPROM checksum is not correct (block number 4,5). System board
UUID needs to be reinstalled.

0190

 Critical low-battery error Critical Low Battery. Charge the battery pack

0191

 System Security. Invalid remote change requested. Bad system configuration change request detected.
  1. Run the BIOS Setup Utility and then save the current setting by pressing the F10 key
  2. System board

0192

 System Security. Embedded Security hardware tamper detected. Security chip ID matching failed. System board

0193

 RF antenna has been removed RFID antenna has been removed,which was once installed. RFID model only

0194

 The computer is carried through a security gate The computer is carried through a security gate (portal gate). RFID model only

0197

 Invalid Remote Change Requested Reported when the CRC of request packet in EEPROM Block #7 is wrong. Recovery-Users need to send the system back to the service centers.
0199 System Security- Security password retry count exceeded System administrator password retry expired (if failed 3 times)
  1. Run the BIOS Setup Utility, and then save current setting by pressing F10.
  2. System Board.

0200

 Failure Fixed Disk Fixed disk is not working or not configured properly. Check to see if fixed disk is attached properly. Run setup. Find out if the fixed-disk type is correctly identified.

0210

 Stuck key Stuck key on keyboard. Run interactive tests of the keyboard and the auxiliary input devices.

0211

 Keyboard error Keyboard not working Run interactive tests of the keyboard and the auxiliary input devices.

0212

 Keyboard Controller Failed Keyboard controller failed test. May require replacing the keyboard controller. Run interactive tests of the keyboard and the auxiliary input devices.

0213

 Keyboard locked. Unlock key switch. Unlock the system to proceed. Run interactive tests of the keyboard and the auxiliary input devices.

0220

 Monitor type does not match CMOS. Run SETUP Monitor type not correctly identified in Setup. Load Setup Defaults in the BIOS Setup Utility.

0230

 Shadow RAM failed at offset nnnn Shadow RAM failed at offset nnnn of the 64k block in which the error was detected. System Board

0231

 System RAM failed at offset nnnn System RAM failed at offset nnnn of in the 64k block in which the error was detected.
  1. DIMM
  2. System Board

0232

 Extended RAM Failed at offset nnnn Extended memory not working or not configured properly at offset nnnn.
  1. DIMM
  2. System Board

0250

 System battery is dead. Replace and run SETUP The CMOS clock battery indicator shows the battery is dead. Replace the battery and run Setup to reconfigure the system Replace the backup battery and run the BIOS Setup Utility to reset the time and date.

0251

 System CMOS checksum bad - default configuration System CMOS has been corrupted or modified incorrectly, perhaps by an application program that changes data stored in CMOS. The BIOS installed Default Setup Values. If you do not want these values, enter Setup and enter your own values. If the error persists, check the system battery or contact your dealer. Replace the backup battery and run the BIOS Setup Utility to reset the time and date.
0260 System timer error The timer test failed. Requires repair of system board.
  1. Replace the backup battery and run the BIOS Setup Utility to reset the time and date.
  2. System Board

0270

 Real time clock error Real-time Clock fails BIOS hardware test. May require board repair.
  1. Replace the backup battery and run the BIOS Setup Utility to reset the time and date.
  2. System Board

0271

 Check date and time settings BIOS found date or time out of range and reset the Real-time Clock. May require setting legal date (1991–2099). Run the BIOS Setup Utility to reset the time and date.

0280

 Previous boot incomplete - Default configuration used Previous POST did not complete successfully. POST loads default values and offers to run Setup. If the failure was caused by incorrect values and they are not corrected, the next boot will likely fail. On system with control of wait states, improper Setup settings can also terminate POST and cause this error on the next boot. Run Setup and verify that wait-state configuration is correct. This error is cleared the next time the system is booted. Customized not to display this message.

0281

 Memory Size found by POST different from CMOS Memory size found by POST different from CMOS. Load Setup Default in the BIOS Setup Utility.
02B0 Diskette drive A error Diskette drive B error Drive A or B is present but fails the BIOS POST diskette tests. Check to see that the drive is defined with the proper diskette type in Setup and that the diskette drive is attached correctly. Load Setup Default in the BIOS Setup Utility.
02B2 Incorrect Drive A type - run SETUP Type of floppy drive A not correctly identified in Setup Diskette Drive
02B3 Incorrect Drive B type - run SETUP Type of floppy drive B not correctly identified in Setup Diskette Drive
02D0 System cache error- Cache disabled RAM cache failed and BIOS disabled the cache. On older boards, check the cache jumpers. You may have to replace that cache. See your dealer. A disabled-cache slows system performance considerably. System Board
02F0 CPU ID CPU socket number for Multiprocessor error.  
02F4 EISA CMOS not writable Server BIOS 2 test error Cannot write to EISA CMOS.
  1. Load Setup Defaults in the BIOS Setup Utility.
  2. Replace the backup battery
  3. System Board
02F5 DMA Test Failed Server BIOS 2 test error Cannot write to extended DMA (Direct Memory Access) registers.
  1. DIMM
  2. System Board
02F6 Software NMI Failed Server BIOS 2 test error Cannot generate software NMI (Non-Maskable Interrupt).
  1. DIMM
  2. System Board
02F7 Fail-safe Timer NMI Failed Server BIOS 2 test error Fail-safe Timer takers too long.
  1. DIMM
  2. System Board

1801

 Unsupported docking station is attached. Attached docking station is not supported by the product. Power off and remove the docking station